![]() I'm trying to communicate with EEC-V on desk. CAN bus form EEC-V is not on pins (due to 60-pin connector which is compatible with EEC-IV connector). I already check all fuses, fixed main chassis ground connectors, visually check all cables and connectors and reflow IC connector.ĮEC-V is 60 pin hardware LP4-331 (98AB-12A650-CFG Visteon, catch code OPEN).Īccording to wiring diagram of my car, only SCP bus is wired to diagnostic connector. Car behave like normal car until next try to start the engine. Dashes on IC disappears, main power relay clicks, fuel pump was enabled and it was possible to start car. Immobilizer led stop blinking (so key was recognized).Īfter some time (i.e. EEC-V is not on pins (due to 60-pin connector which is compatible with EEC-IV connector). Battery was discharged.Īfter fixing battery car didn't start - dashes on Instrument Cluster. I'm trying to solve problem with no communication between Instrument Cluster and EEC-V. ![]() ![]() It was working perfectly for years with my ForDiag interface V2. My car is Focus MK1 1999 1.8 16V, Petrol.
0 Comments
Leave a Reply. |